Configuration - Weidmüller WAVECONTROL WAS2 VMA Vac Notice D'utilisation

3.

Configuration

3.1 Equipment
A screwdriver with a width of 2.5 mm is required to adjust the unit and to
connect the wires to the terminals.
2
3.2 Opening the unit
Disconnect the plugs. Disengage the top part
of the housing by carefully pressing the latches
on both sides (1). Pull out the top part of the
1
1
housing and the electronics section until they
lock (2).
3.3 Settings
The input voltage and the output signals
are selected in accordance with the following
SW1
tables.
11