Display Operations; Dcp - Clarion DXZ948RMP Mode D'emploi

Display Operations

A touch panel display is used as the display on
this unit. You can operate this display just by
touching it with your fingertip. There are four
main display operations as follows:
Touch
Touch the display with your fingertip and take it
away within 1 second. This is the most basic
operation when operating the display.
Touch and hold
Touch the display with your fingertip and hold it
on the display for 1 or 2 seconds or longer. Do
not move your finger while you are touching the
display.
Touching and holding the display for 1 second or
longer displays lists, for example, and calls up
other handy functions.
Touching and holding the display for 2 seconds
or longer is used for storing preset memory or
other information.
8
DXZ948RMP
Touch
Touch the display with your fingertip, and move
your finger to the left ( ) or right ( ) with your
fingertip still touching the display, and take your
fingertip away within 1 second. This operation is
used for selecting preset memory (1 to 6) or
tracks.
98.10MHz
Touch
Touch the display with your fingertip, and move
your finger to the left ( ) or right ( ) with your
fingertip still touching the display, and keep your
fingertip on the display. The current operation
continues for the time your fingertip is held on
the display. This operation is used, for example,
for manual tuning or fast-forwarding/fast-
backwarding tracks.
98.10MHz

4. DCP

The control panel can be detached to prevent
theft. When detaching the control panel, store it
in the DCP (DETACHABLE CONTROL PANEL)
case to prevent scratches.
We recommend taking the DCP with you when
leaving the car.
Removing the DCP
1. With the SLOPING CONSOLE closed, turn
off the power.
2. Press the [RELEASE] button deeply to open
the DCP.
[RELEASE] button
3. Pull the DCP toward you and remove it.
DCP
CAUTION
• Always close the SLOPING CONSOLE
before removing the DCP.
• If you remove the DCP with the SLOPING
CONSOLE open, the sloping console
closes immediately. Be careful not to get
your fingers caught.
Attaching the DCP
1. Insert the DCP so that the A section on the
right side of the DCP catches on the hook B
on the unit.
2. Press the left side C of the DCP carefully to
fit it in place.
CAUTION
• The DCP can easily be damaged by shocks.
After removing it, be careful not to drop it
or subject it to strong shocks.
• If the [RELEASE] button is pressed and the
DCP is not locked into place, it may fall out
from vibration of the car. This can break the
DCP, so after removing it, either install it on
the unit or put it in its DCP case.
• The connector connecting the unit and the
DCP is an extremely important part. Be
careful not to damage it by pressing on it
with fingernails, screwdrivers, etc.
Note:
• If the DCP is dirty, wipe off the dirt with a soft, dry
cloth only.
DXZ948RMP
9