Maintenance; Disposal - Trotec INT PJSS 10-230V Traduction De La Notice Originale

Maintenance

Activities required before starting
maintenance
Warning of electrical voltage
Do not touch the mains plug with wet or
damp hands.
• Switch off the device.
• Hold onto the mains plug while pulling the
power cable out of the mains socket.
• Allow the device to cool down completely.
Warning of electrical voltage
Maintenance tasks which require the
housing to be opened must only be
carried out by authorised specialist
companies or by Trotec.
Notes on maintenance
Inside the device, there are no parts that need to be
maintained or lubricated by the user.
Cleaning
The device should be cleaned before and after each
use.
Note
The device does not have to be
lubricated after cleaning.
Warning of electrical voltage
There is a risk of a short-circuit due to
liquids penetrating the housing!
Do not immerse the device and the
accessories in water. Make sure that no
water or other liquids can enter the
housing.
• Clean the device with a soft, damp and lint-
free cloth. Make sure that no moisture enters
the housing. Protect electrical components
from moisture. Do not use any aggressive
cleaning agents such as cleaning sprays,
solvents, alcohol-based or abrasive cleaners
to dampen the cloth.
42
•
•
•
•
•

Disposal

waste electrical or electronic equipment stipulates
that this equipment must not be disposed of with
the household waste at the end of its life. You will
find collection points for free return of waste
electrical and electronic equipment in your vicinity.
The addresses can be obtained from your
municipality or local administration. You can also
find out about other return options that apply for
many EU countries on the website
https://hub.trotec.com/?id=45090. Otherwise,
please contact an official recycling centre for
electronic and electrical equipment authorised for
your country.
The separate collection of waste electrical and
electronic equipment aims to enable the re-use,
recycling and other forms of recovery of waste
equipment as well as to prevent negative effects for
the environment and human health caused by the
disposal of hazardous substances potentially
contained in the equipment.
850W pendulum action jigsaw PJSS 10-230V
Dry the device with a soft, lint-free cloth.
Dry the saw blades with a soft, lint-free cloth.
Remove any dust deposits and, if applicable,
wood chips or material residues from the
quick-release chuck.
Keep the ventilation openings free from dust
deposits to prevent overheating of the motor.
Remove dust and chips from the chip ejector.
If the chip ejector is blocked, clean it with
suitable means (e.g. compressed air).
The icon with the crossed-out waste bin on
EN