Intended Use; Foreseeable Misuse; Personnel Qualifications; Personal Protective Equipment - Trotec INT PJSS 10-230V Traduction De La Notice Originale

Only hold the power tool against the
•
workpiece when the tool is switched on
and running. Otherwise there is a risk of
kickbacks.
• Make sure that the base plate is
positioned securely on the contact face
during sawing. A jammed saw blade could
break or cause a kickback.
• Keep your hands out of the sawing area.
Do not reach underneath the workpiece. Risk
of injury upon contact with the saw blade.
• Keep your hands away from lifting rod and
quick-release chuck. Crushing hazard upon
contact with these components.
• Ensure sufficient ventilation.
• Regularly check the quick-release chuck
for wear or damage.
• Only use intact, flawless saw blades. Bent
and blunt saw blades could break or cause a
kickback.
• Do not attempt to slow down the saw
blade movement by pressing against the
blade from the side once the device is
switched off. The saw blade could be
damaged, break or cause a kickback.
• Switch off the power tool when your
operation is completed, but do not remove
the saw blade from the kerf until it has
come to a standstill. This serves to avoid a
kickback, then you can put the power tool
down safely.
• Immediately switch off the power tool if
the insertion tool blocks. The power tool
can lash out to the side owing to the forces
that build up consequently.
• Wait until the power tool has come to a
standstill, before putting it down. The
insertion tool could get caught resulting in a
loss of control of the power tool.
28

Intended use

Only use the device
•
•
whilst adhering to the technical data (see
instructions).
We recommend using the power tool with original
Trotec accessories.

Foreseeable misuse

•
•
•
Any other use than the one described in the chapter
"Intended use" is regarded as reasonably
foreseeable misuse.

Personnel qualifications

People who use this device must:
•
Make sure that the device is not used by children
under 16 years of age.

Personal protective equipment

850W pendulum action jigsaw PJSS 10-230V
PJSS 10-230V:
for straight and curved cuts at angular
workpieces made of wood, plastic and light
metal while keeping base plate contact,
for mitre cuts up to an angle of 45° at
angular workpieces made of wood, plastic
and light metal,
The device is not intended for processing
damp wood.
The device is not intended for processing
glass or stone.
The device is not intended for freehand
operation without base plate contact.
have read and understood the instructions,
especially the Safety chapter.
Wear hearing protection.
Excessive noise can lead to hearing loss.
Wear eye protection.
With it you protect your eyes from
splintering, falling and flying pieces which
could cause injuries.
EN