Operation - Trotec INT PJSS 10-230V Traduction De La Notice Originale

1. Set the pendulum action selector switch (5)
to the desired level. The higher the level, the
larger the pendulum stroke. The pendulum
action can also be adjusted during operation.
0
I
II
III
Connecting the power cable
1. Insert the mains plug into a properly secured
mains socket.

Operation

Tips and notes on handling the jigsaw
General information:
• Keep the venting slots clear to prevent the
motor from overheating.
• Check the tool in the tool holder for proper fit
before every application. The tool must be
firmly locked in place in the designated
holding fixtures in the tool holder.
• Before every application, make sure that you
have selected the correct tool for the
intended use.
38
Sawing:
Switching the LED work light and laser on and
5
off
The device is equipped with an LED work light to
illuminate the workpiece and with a laser to mark
the cutting path. The laser is best suited for cuts
with a 0° cutting angle.
850W pendulum action jigsaw PJSS 10-230V
• Only use intact, flawless saw blades. Bent,
blunt or otherwise damaged saw blades
could break.
• When sawing lightweight construction
materials, make sure to observe the legal
regulations and recommendations of the
material manufacturers.
• Before sawing wood, chipboards, building
materials etc. with HCS blades, check the
above for foreign objects, e.g. nails, screws
or similar. If required, remove the foreign
objects or use HSS saw blades.
• Use a narrow saw blade when sawing tight
curves.
• The saw blade should not be longer than
required for the intended cut.
Warning of laser radiation
Laser class 2, P max.: < 1 mW, λ:
400-700 nm, EN 60825-1:2014
Do not look directly into the laser beam
or the opening from which it emerges.
Never point the laser beam at people,
animals or reflective surfaces. Even brief
eye contact can lead to eye damage.
Examining the laser output aperture by
use of optical instruments (e.g.
magnifying glass, magnifiers and the
like) entails the risk of eye damage.
When working with a laser of class 2,
observe the national regulations on
wearing eye protection.
EN