Residual Risks - Trotec INT PJSS 10-230V Traduction De La Notice Originale

Wear a protective mask.
It saves you from inhaling harmful dusts
generated when processing workpieces.
Wear protective gloves.
They protect your hands from burns,
crushing injuries and skin abrasions.
Wear tight-fitting protective clothing.
This protects you from the draw-in and
entanglement hazard posed by rotating
parts.

Residual risks

Warning of electrical voltage
Electric shock from insufficient
insulation.
Check the device for damages and
proper functioning before each use.
If you notice damages, no longer use the
device.
Do not use the device when the device
or your hands are damp or wet!
Warning of electrical voltage
Work on the electrical components must
only be carried out by an authorised
specialist company!
Warning of electrical voltage
Before any work on the device, remove
the mains plug from the mains socket!
Do not touch the mains plug with wet or
damp hands.
Hold onto the mains plug while pulling
the power cable out of the mains socket.
Warning of electrical voltage
There is a risk of a short-circuit due to
liquids penetrating the housing!
Do not immerse the device and the
accessories in water. Make sure that no
water or other liquids can enter the
housing.
EN
850W pendulum action jigsaw PJSS 10-230V
Warning of electrical voltage
Electric shock due to lightning strike.
Do not work outdoors in case of
approaching thunderstorms.
In case of a thunderstorm, disconnect
the device from the mains.
The operator is responsible for the
lightning protection of the building.
Warning of laser radiation
Laser class 2, P max.: < 1 mW, λ:
400-700 nm, EN 60825-1:2014
Do not look directly into the laser beam
or the opening from which it emerges.
Never point the laser beam at people,
animals or reflective surfaces. Even brief
eye contact can lead to eye damage.
Examining the laser output aperture by
use of optical instruments (e.g.
magnifying glass, magnifiers and the
like) entails the risk of eye damage.
When working with a laser of class 2,
observe the national regulations on
wearing eye protection.
Warning of hot surface
The insertion tool might still be hot after
the application. Burn hazard when
touching the insertion tool.
Do not touch the insertion tool bare-
handed!
Wear protective gloves!
Warning of hand injuries
Crushing hazard near saw blade and
base plate if handled without due care.
Wear protective gloves!
Warning of sharp object
Parts of the saw blade are sharp. Risk of
injuries if handled without due care.
Wear protective gloves!
29