Scope of delivery
•
1 x Pendulum action jigsaw
•
1 x Rip fence
•
3 x Saw blade HCS wood
•
1 x Saw blade HSS metal
•
1 x Adapter for dust extraction
•
1 x Anti-splinter guard
•
1 x Sliding block
•
1 x Manual
Technical data
Parameter
Model
Power supply
Power consumption
Idle speed
Cutting angle
Max. cutting depth (mm)
Wood
Metal
Plastic
Cable length
Protection class
Weight
Vibration information according to EN 62841
Total vibration emission value:
Sawing chipboards a
h,B
Uncertainty K
Sawing sheet metal a
Uncertainty K
Sound values according to EN 62841
Sound pressure level L
Sound power L
WA
Uncertainty K
32
Value
PJSS 10-230V
230 V / 50 Hz
0.85 kW
0 – 3,000 rpm
0° / 15° / 30° / 45°
80
8
10
3 m
II (double insulation) /
2 kg
9.5 m/s²
1.5 m/s²
11.2 m/s²
h,B
1.5 m/s²
88 dB(A)
pA
99 dB(A)
3 dB
850W pendulum action jigsaw PJSS 10-230V
Wear hearing protection.
Excessive noise can lead to hearing loss.
Information on noise and vibration:
•
The specified total vibration and noise
emission values were measured by means
of a test procedure standardized in EN 62841
and can be consulted for the comparison of
one power tool with another.
•
The specified total vibration and noise
emission values can also be used for
preliminary load assessment.
Caution
Vibration emissions can cause a health
hazard if the device is used for an
extended period of time or if it is not
properly handled and maintained.
•
The actual vibration and noise emission
may differ from the stated values during
operation of the power tool. This depends on
how the power tool is used and especially on
the type of workpiece being processed. Try to
keep the vibration load to a minimum.
Exemplary measures for reducing the
vibration load include wearing gloves during
operation of the tool and the limitation of
working hours. All parts of an operating cycle
must be considered for this (e.g. times at
which the power tool is switched off and
times when it is switched on but runs without
load).
EN