Home Position Adjust - Nicols BIRDY WASH 122 Manuel D'utilisation

Press the MENU button up to when the Auto-Test is blinking on the display. Pressing
ENTER button and the unit will run self-test by built-in program. To go back to the functions
press the MENU button again. Hold and press the MENU button about one second or wait
for one minute to exit the menu mode.
Temperature
Press the MENU button up to when the Temperature Test is blinking on the display.
Pressing ENTER button and the display will show the temperature of the unit. To go back to
the functions press the MENU button again. Hold and press the MENU button about one
second or wait for one minute to exit the menu mode.
Fixture Time
Press the MENU button up to when the Fixture Time is blinking on the display. Pressing
ENTER button and the display will show the number of working hours of the unit. To go back
to the functions press the MENU button again. Hold and press the MENU button about one
second or wait for one minute to exit the menu mode.
Firmware Version
Press the MENU button up to when the Firmware version is blinking on the display.
Pressing ENTER button and the display will show the version of software of the unit. To go
back to the functions press the MENU button again. Hold and press the MENU button about
one second or wait for one minute to exit the menu mode.
PRO Defaults
Press the MENU button to show PRO Defaults on the display. Press the ENTER button and
the display will blink. Use the DOWN and UP button to select the Yes (run built-in program
to set the fixture to PRO Defaults settings) or No. Press the ENTER button to setup, to go
back to the functions without any change press the MENU button again. Hold and press the
MENU button about one second or wait for one minute to exit the menu mode.
Reset
Press the MENU button up to when the Reset is blinking on the display. Pressing ENTER
button and all channels of the unit will return to their standard position.

3.3 Home Position Adjust

28B