Nicols BIRDY WASH 122 Manuel D'utilisation page 28

Select Pan Inverse, press the ENTER button to confirm, present mode will blink on the
display. Use the DOWN and UP button to select the Yes (tilt inversion) or No (normal) mode.
Once the mode has been selected, press the ENTER button to setup, to go back to the
functions without any change press the MENU button again. Hold and press the MENU
button about one second or wait for one minute to exit the menu mode.
Back Light
Select Back Light, press the ENTER button to confirm, present mode will blink on the
display. Use the DOWN and UP button to select the On (Led on) or Off (Led off) mode.
Once the mode has been selected, press the ENTER button to setup, to go back to the
functions without any change press the MENU button again. Hold and press the MENU
button about one second or wait for one minute to exit the menu mode.
Function Delay
Select Function Delay, press ENTER button to confirm, present mode will blink on the
display. Use DOWN and UP button to select the No Delay or 1S/2S/3S Delay (Wait for 1/2/3
seconds before these Functions of 9/16/28CH are activated/deactivated) mode. Once the
mode has been selected, press the ENTER button to setup, to go back to the functions
without any change press the MENU button again. Hold and press the MENU button about
one second or wait for one minute to exit the menu mode.
White Balance
Select White Balance, press the ENTER button to confirm, present mode will blink on the
display. Use the DOWN and UP button to select the Red or Green or Blue. Once the mode
has been selected, press the ENTER button to setup, use the DOWN and UP button to
change the value (125~255). Once the mode has been selected, press the ENTER button to
setup, go back to the functions without any change press the MENU button again. Hold and
press the MENU button about one second or wait for one minute to exit the menu mode.
Manu Test
Select Manu Test, press the ENTER button to confirm, present mode will blink on the
display. Use the DOWN and UP button to select the Pan/ Tilt/ Red1/ Green1/ Blue1/
White1/...Red4/ Green4/ Blue4/ White4/ Dimmer or Strobe. Once the mode has been
selected, press the ENTER button to setup, use the DOWN and UP button to change the
value (0~255). Once the mode has been selected, press the ENTER button to setup, go
back to the functions without any change press the MENU button again. Hold and press the
MENU button about one second or wait for one minute to exit the menu mode.
Auto-Test
27B