Nicols BIRDY WASH 122 Manuel D'utilisation page 26

Select DMX Address, press the ENTER button to confirm, the present address will blink on
the display. Use the UP and DOWN button to adjust the address from 1 to 512. Once the
address has been selected, press the ENTER button to setup, to go back to the functions
without any change press the MENU button again. Hold and press the MENU button about
one second or wait for one minute to exit the menu mode.
Channel Mode
Select Channel Mode, press the ENTER button to confirm, present mode will blink on the
display. Use the DOWN and UP button to select the 9 chan or 12 chan or 14 chan or 16
chan or 28 chan mode. Once the mode has been selected, press the ENTER button to
setup, to go back to the functions without any change press the MENU button again. Hold
and press the MENU button about one second or wait for one minute to exit the menu mode.
Show Mode
Select Show Mode, press the ENTER button to confirm, present mode will blink on the
display. Use the DOWN and UP button to select the Show 1 or Show 2 or Show 3 or Show
4 mode. Once the mode has been selected, press the ENTER button to setup, to go back to
the functions without any change press the MENU button again. Hold and press the MENU
button about one second or wait for one minute to exit the menu mode.
Dimmer curve
Select Dimmer curve, press the ENTER button to confirm, present mode will blink on the
display. Use the DOWN and UP button to select the Mode1 or Mode 2 or Mode 3 or Mode 4
mode. Once the mode has been selected, press the ENTER button to setup, to go back to
the functions without any change press the MENU button again. Hold and press the MENU
button about one second or wait for one minute to exit the menu mode.
Mode 1(Optically Linear): The increase in light intensity appears to be linear as DMX value
is increased.
Mode 2(Square Law): Light intensity control is finer at low levels and coarser at high levels.
Mode 3(Inverse Square Law): Light intensity control is coarser at low levels and finger at
25B