Safety Precautions - McCulloch MiniMac 14 Manuel D'utilisation

7. Only use replacement bars and chains specified by the manufacturer or
the equivalent.
Low-kickback saw chain and bar have met the kickback performance
NOTE
requirements of ANSI B175.1-1991 and is in accordance with CSA
Z62.3.
When using an electric chain saw, basic safety precautions should
always be read and followed to reduce the risk of fire, electric shock and
injury to persons.
Read All Instructions
1. DOUBLE INSULATED - No Serviceable Parts Inside.
2. TO REDUCE THE RISK OF ELECTRICAL SHOCK, this equipment
has a polarized plug (one blade is wider then the other) and will
require the use of a polarized extension cord. This plug will fit in a
polarized extension cord only one way. A polarized extension cord will
require the use of a polarized wall outlet. This plug will fit into the polar-
ized wall outlet only one way. If the plug does not fit fully into the wall
outlet, reverse the plug. If it still does not fit, contact a qualified electri-
cian to install the proper outlet. Do not change the equipment plug,
extension cord receptacle or extension cord plug in any way.
3. POWER SUPPLY: Connect the chain saw to correct voltage; be sure
that the voltage supplied is the same as that specified on the name-
plate of the tool.
4. KEEP THE WORK AREA CLEAN: Cluttered areas invite injuries. Do
not start cutting until you have a clear work area, secure footing, and a
planned retreat path from the falling tree.
5. CONSIDER THE WORK AREA ENVIRONMENT: Use extreme caution
when cutting small sized brush and sapling, as slender material may
catch the saw chain and be whipped toward you or pull you off bal-
ance. Do not operate a chain saw in a tree unless you are specifically
trained to do so. When cutting a limb that is under tension, be alert for
spring back so that you will not be struck when the tension in the wood
fibers is released. Do not expose the chain saw to rain.
6. GUARD AGAINST ELECTRIC SHOCK: Prevent body contact with
grounded surfaces (i.e., metal pipes, wire fences).
7. KEEP CHILDREN AND BYSTANDERS AWAY: Do not let visitors con-
tact the chain saw or extension cord. All visitors should be kept away
from the work area.
8. STORE THE IDLE CHAIN SAW: When not in use, chain saws should
be stored out of the reach of children, in a dry, high or locked place.
When storing saw, use a scabbard or carrying case.
9. DO NOT FORCE THE CHAIN SAW: The chain saw will do a better
and safer job when used at the rate for which it was intended.
10. USE THE RIGHT TOOL: Cut wood only. Do not use the chain saw
for purposes for which it was not intended. For example, do not use
the chain saw for cutting plastic, masonry or non-building materials.
11. DRESS PROPERLY AND USE SAFETY GEAR: Do not wear loose
clothing or jewelry, as they can get caught in moving parts. Non-skid
safety footwear is recommended when working outdoors. Wear protec-
tive hair covering to contain long hair. Use safety glasses, protective
gloves and hearing protection along with safety head gear.
12. CARRYING THE SAW: Carry the saw by the front handle with the saw
stopped. Keep your finger off the switch, and make sure that the guide
bar and saw chain are to the rear.
13. MAINTAIN THE CHAIN SAW WITH CARE: Inspect the chain saw cord
periodically and, if damaged, have it repaired by an authorized service
facility. Keep the cord clear of the chain and operator at all times.
Never carry the saw by the cord or pull it to disconnect from recepta-
cle. Keep the cord from oil and sharp edges. Inspect extension cords
periodically and replace if damaged. Follow instructions for lubricating
and changing accessories. Keep handles dry, clean and free from oil
and grease.
Toll Free Hot Line: 1-800-521-8559

Safety Precautions

14. DISCONNECT THE CHAIN SAW: Disconnect the chain saw when not
in use, before servicing and when changing accessories and attach-
ments such as saw chain and guard.
15. OUTDOOR EXTENSION CORDS: Use only extension cords with
polarized plugs that are intended for outdoor use.
16. STAY ALERT: Watch what you are doing. Use common sense. Do not
operate the chain saw when you are tired. Keep body parts away from
the saw chain when the motor is operating. Before you start the saw,
make sure the saw chain is not in contact with anything.
17. CHECK DAMAGED PARTS: Before using chain saw, check to deter-
mine that it will operate properly and perform its intended function.
Check for alignment of moving parts, binding of moving parts, break-
age of parts, mounting and any other conditions that may affect its
operation. Any damaged part should be properly repaired or replaced
by an authorized service center unless otherwise indicated in this
instruction manual. DO NOT operate a chain saw that is damaged,
improperly adjusted, or not completely and securely assembled. Be
sure that the saw chain stops moving when the trigger is released.
18. REPLACEMENT PARTS - When servicing use only identical replace-
ment parts. Bars and chains specified by McCulloch must be used to
achieve kickback protection in accordance with CSA Z62.3.
19. DO NOT attempt operations beyond your capacity or experience.
Operation of a chain saw should be restricted to mature, properly
instructed individuals.
20. DO NOT operate a chain saw with one hand! Serious injury to the
operator, helpers or bystanders may result from one-handed operation.
A chain saw is intended for two-handed use.
21. TO REDUCE potential for electric shock, do not use chain saw in
damp, wet or slippery locations, or during snow storms, rain storms
and other adverse weather conditions.
22. DO NOT allow dirt, debris or sawdust to build up on the motor or out-
side air vents.
23. Follow the manufacturer's sharpening and maintenance instructions for
the saw chain.
24. Cut at high motor speeds.
25. DO NOT FORCE a small saw to do a job requiring a heavier duty unit.
26. EXAMINE THE ELECTRICAL SWITCHES. Do not use the chain saw if
the switches do not properly turn on and off. Do not attempt to make
any repairs to the electric switches. Take your saw to a McCulloch
Authorized Service Center.
27. DO NOT OPERATE YOUR CHAIN SAW near or around flammable liq-
uids or gases, whether in or out of doors. An explosion and/or fire may
result.
28. All chain saw service, other than the items listed in the user manual
safety and maintenance instructions, should be performed by compe-
tent chain saw personnel. Do not attempt to repair it yourself; there are
no serviceable parts inside.
29. NEVER REMOVE, modify or make inoperative any safety device fur-
nished with your unit.
30. This electric powered saw is classified by CSA as a Class 2C saw. It is
intended for infrequent use by homeowner's, cottagers and campers,
and for such general applications such as clearing, pruning, cutting
firewood, etc. It is not intended for prolonged use. If the intended use
involves prolonged periods of operation, this may cause circulatory
problems in the user's hands due to vibration. It may be appropriate to
use a saw having an anti-vibration feature.
31. WHEN FELLING, keep at least 2 tree lengths between yourself and
your fellow workers.
3