Publicité
Les langues disponibles
Les langues disponibles
The number of degrees to be bent with each passage will be equal to 90°/16 = 5.40°
We will take 6°.
Bending:
Put sector 1 of the tube into the shoe axis.
Wedge the ends of the tube.
Bend until you achieve the 6° determined above (check with a protractor: the bender cylinder is idle).
Then move onto sector 2 and so on until the full bend is performed.
As the bending for each sector is not very precise, check the angle obtained after bending sectors 14 then 15 to avoid
exceeding 90° on sector 16.
Existing compositions to bend medium series and strong series tubes.
- 240252: 9 forms from 3/8" to 3" 240141 to 240149 (see table page 16).
- 240851: delivered with 9 forms from 3/8" to 3" references 240141 to 240149, 2 shoes of 3"1/2 and 4" references
240124 and 240125 (see table page 16).
- 240852: delivered with 9 forms from 3/8" to 3" references 240141 to 240149 (see table page 16).
Components
Manual cylinder No.3
Pumping lever
Lever extension
Cylinder No.3 - 230V monophase
Adaptor
Hinged flange 3/8" to 3"
Roller for hinged flange 3/8" to 3" (x1)
Upper flange 2"1/2 to 4"
Lower flange 2"1/2 to 4"
Roller for flanges 2"1/1 to 4" (x1)
Case 1625 x 310 x 680 mm
Case 800 x 395 x 295 mm
Case 1220 x 365 x 438 mm
Options available:
- Forms from 3/8" to 1"1/2 for light series tubes (see table page 16)
- Forms from 12mm to 50mm for locksmith tubes (see table page 16)
- Tripod for hinged flange only 240106
WARNING: When using 3" cylinders with flanges 2"1/2 to 4", you must use the lever extension 240208 to remove
any risk of damaging the piston seal.
tube
e
Manual 2402/3 and electric 2408/3 hydraulic benders
240203
240200
240204
240803
240205
240228
240120
240223
240222
240117
240130
240127
240188
wed
ge
240252
240851
•
•
•
•
•
•
•
••
••
•
•
••
•
•
•
•
Tube
e (mm)
3"1/2
60
4"
55
240852
•
•
••
•
•
EN
16
Publicité
