Virax 2402 Manuel D'utilisation page 14

Existing compositions to bend medium series and strong series tubes.
Compositions delivered with 5 forms from 3/8" to 1"1/4 referenced 240141 to 240145 (see table page 16).
Components
Manual cylinder No.1
Pumping lever
Sliding flanges
FC roller (x1)
Case 652 x 350 x 295 mm
Existing compositions to bend medium series and strong series tubes.
Compositions delivered with 7 forms from 3/8" to 2" referenced 240141 to 240147 (see table page 16).
Manual cylinder No.2
Pumping lever
Cylinder No.2 - 230V monophase
Open flange
FO roller (x1)
Sliding flanges
FC roller (x1)
Manual bender case 800 x 395 x 295 mm
Electric bender case 870 x 362 x 434 mm
Options available:
- Forms from 3/8" to 1"1/2 for light series tubes (see table page 16)
- Forms from 12 mm to 50 mm for locksmith tubes (see table page 16).
- Forms of 40, 50, 63 mm and rollers for multilayer tubes, only with sliding flanges (see table page 16).
- Run limiter for electric cylinder 240811
- Low base tripod for open flange 240103
- Wide base tripod for open flange 240107
- Tripod for sliding flanges 240105
- Bending complement for tubes from 2"1/2 to 4" 240248
Manual hydraulic bender 2402/1
with hydraulic cylinder No.1
240201
240200
240211
240111
240126
Manual 2402/2 and electric 2408/2 hydraulic benders
with hydraulic cylinder No.2
Components
240233
• Forms from 3/8" to 1" to bend light series tubes (see table
•
page 16)
•
Forms from 12 mm to 25 mm to bend locksmith tubes (see
••
table page 16)
•
240202
240200
240802
240216
240114
240217
240115
240127
240186
Options available
240242 240243 240842
• •
• •
•
••
•
••
• •
EN
240843
• •
•
••
•
••
• •
14