AKG PR40 Mode D'emploi page 13

LED lighting red: audio section is
overloaded.
LED does not light: audio level is too
low.
BATT: Indicates battery status:
LED lights green: batteries are O.K.
LED does not illuminate on switch-
ing the power ON: no or dead batte-
ries in the battery compartment.
LED lights red: batteries will be dead
in about 60 minutes.
Antennas: Being a diversity receiver,
the PR 40 uses two antennas to
receive the transmitter signals at two
different spots. The diversity circuit
will automatically activate the anten-
na that provides the better signal.
Battery compartment: Accepts the
supplied 1.5 V dry batteries or
rechargeable batteries of the same
size (not supplied).
Fig. 2: Bottom and rear panels.
2.5.2 Rear Panel (Fig. 2)
Type plate with approval marks and
frequency information (frequencies,
frequency sets, color code).
Belt clip for fixing the receiver on
your belt.
2.5.3 Bottom Panel (Fig. 2)
Charging contacts for charging
rechargeable batteries inside the bat-
tery compartment using the optional
CU 40 charger.
13