Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INITIALISING
When the "Initialise" function is displayed the vending
machine can be initialised restoring all default data.
This function should be used the first time the machine is
switched on and in the event of a memory data error or
reprogramming of the board.
All statistic information will be reset.
Press confirm button " " and the display will indicate the
message "Confirm?". Press the button " " again to display
the first variable parameter to define the machine configu-
ration.
The available options (blinking) can be scrolled with the " "
and " " buttons, the selection is confirmed with button " "
and the next parameter is presented. When pressing
button " " after the last parameter the display will show the
message "Working" for a few seconds and the machine is
initialised.
The parameters are as follows:
"Country"
Type of doses to be
used for the selections
"Layout"
Layout of containers and
selection menu from the
available ones
"Tank"
Water supply from the mains
or from a tank
N.B.: When the machine is switched on for the first time or
in any case after initialising, as well as the list of controls to
be performed, also the language used for the messages on
the display is proposed.
The available languages can be scrolled with the " " and
" " buttons, and the selection is confirmed with button " ".
Unless the machine is initialised, the language request is
not made again.
© by N&W GLOBAL VENDING SpA
FILLING THE WATER SYSTEM
When the machine is switched on the conditions of the
boiler are checked.
If required by the conditions, the machine will automatically
start an installation cycle, and namely:
- the message "Installation" will be shown on the display
for the entire duration of the cycle;
- the water mains solenoid valve is opened or the pump
is started to fill the boiler.
N.B.: If there is no water flow from the mains during the
installation cycle, the machine will stop until water is
resumed or the machine is switched off.
IMPORTANT NOTICE!!!
If a considerable amount of air bubbles is formed in the
water system, for example during maintenance, it is pos-
sible that an installation cycle is automatically started when
the machine is switched on.
14
0603 265 - 00
Publicité
Table des Matières
