Replacement Parts; Guarantee - Rodia 130-H Manuel D'utilisation

RODIA
Motor makes too
much noise.
Motor mildly over-
heats.
Motor runs. Core bit
doesn't rotate.
Rate of drilling pro-
gress decreases.
Motor cuts out.
Water leakage at the
water swivel or gear
housing.

REPLACEMENT PARTS

If – in spite of meticulous manufacturing and
testing processes – the device breaks down,
have it serviced by a Rodia Service.

GUARANTEE

For this Rodia appliance we grant a warranty
in accordance with the statutory/country-spe-
cific provisions as from date of purchase (by
evidence of invoice or delivery note). Damage
that has occurred will be corrected either by
replacement or by repair.
® 130/164/300
Damaged windings.
The carbon brushes of the machine
are worn.
Motor overload.
Motor doesn't cool sufficiently
Gearing defective.
Core bit segments polished.
Water pressure/water flow rate
too high.
The core is stuck in the core bit.
Maximum drilling depth reached.
Core bit defective.
Gearing defective.
The clutch is releasing prematurely
or slipping.
The core bit has been jammed for
too long.
Electric power failure.
Electronics defective.
Shaft seal defective.
Water pressure is too high.
Have the motor inspected by
customer service.
Prevent motor overload when drill-
ing.
Remove the dust from the motor, so
that the cool air can flow.
Have the machine inspected by the
service facility.
Sharpen the core bit on a sharpen-
ing plate while water is flowing.
Use the feed lever to reduce the
water flow rate.
Remove the core.
Remove the core and use a core
bit extension.
Check the core bit for damage and
replace if necessary.
Have the machine repaired at a
service center.
Have the machine repaired at a
service center.
Free the core bit. Switch the motor
off and then on again.
Check the plug connections, elec-
tric power supply and PRCD pro-
tective switch.
Have the machine repaired at a
service center.
Have the machine repaired at a
service center.
Reduce the water pressure.
Damage caused by improper handling is
excluded from the warranty.
Claims can be recognized only if the appli-
ance is presented in a not-disassembled man-
ner to a Rodia branch office, your Rodia field
service employee or a customer service office
for power tools authorized by Rodia.
27
GB