RODIA
Actuate the ON/OFF switch 2.
•
Drill using an even forward feed. Do not
•
overload the machine.
•
The leaking water should be milky and not
clear.
Always loosen the locking screw 16
•
(Rodia 130/164) or the clamping lever
35 (Rodia 300) when drilling.
•
After drilling switch the machine off and
shut off the water tap.
DRILL STAND FIXATION
CAUTION: The drill stand must
always be mounted firmly and must
not be able to move during drilling.
Secure using assembly
•
Drill the rawlplug hole Ø 15/16 mm (see
instruction rawlplug).
•
Insert rawlplug SD M12
Screw in assembly 25.
•
•
Align the drill stand.
•
Fasten the drill stand with the spindle nut
24.
Vacuum pump fixation
Setting up the vacuum pump
•
Position the machine horizontally. Maxi-
mum tilt of 10°.
Fasten, mount suction hose 42 and fasten
•
with hose clip 41.
WARNING: Maximum drilling diam-
eter of 100 mm. Mount the drill
stand on an even, firm and smooth
surface using the vacuum pump,
never "over" head. Always con-
nect the core drill and the vacuum
pump to the same power outlet.
Never turn off the vacuum pump
during operation.
®
130/164/300
•
•
•
•
•
•
•
•
•
•
•
Empty the fluid collecting container
•
•
•
•
OVER HEAD DRILLING
25
Install the vacuum kit.
Turn the fixation screws 21 ensuring, how-
ever, that the seal 29 is not squeezed.
Align the drill stand.
Mount the suction hose to the connection
for the vacuum pump 27.
Close the ventilating tap 28.
Connect quick coupling 43 to vacuum kit
27 on the drill stand.
The machine has no On/Off switch; it is
put into operation by inserting the mains
plug 45 into the socket.
The existing vacuum can be read from the
vacuum gauge 40.
The vacuum gauge 40 must show a
vacuum of below -0.65 bar. If not check
for leakage.
Do not commence work until the required
vacuum has been reached.
Watch the vacuum gauge 40 while work-
ing. If the vacuum rises above -0.65 bar,
interrupt the work immediately and com-
pletely remove the drill stand.
If fluid is sucked in during operation, the
vacuum will no longer be maintained. Pull
the mains plug out immediately.
Unscrew the fluid collecting container 44.
Remove the float and empty the container.
Replace the float and screw on the con-
tainer tightly again.
CAUTION: The machine becomes
hot after a long period of use. Do
not touch the machine directly after
operating it.
DANGER: When drilling "over"
head always secure the drill stand
with the assembly.
GB