Safety Guidelines; Intended Use; Before Use; Initial Operation - Rodia 130-H Manuel D'utilisation

GB
*Not all of the accessories illustrated or described are
included as standard delivery

SAFETY GUIDELINES

The definitions below describe the level of
severity for each warning. Please read the
operating manual and pay attention to these
symbols.
DANGER: Indicates an imminently
hazardous situation which, if not
avoided, will result in death or seri-
ous injury.
WARNING: Indicates a potentially
hazardous situation which, if not
avoided, could result in death or
serious injury.
CAUTION: Indicates a potentially
hazardous situation which, if not
avoided, may result in minor or
moderate injury.
NOTE: Indicates a practice not relat-
ed to personal injury which, if not
avoided, may result in property
damage.

INTENDED USE

The machine is intended for drilling into con-
crete and reinforced concrete, when being
used in conjunction with diamond core bits
for wet drilling and a suitable water supply.
Rodia 130 can also be used for dry drilling in
masonry and other building materials with the
dry drilling kit.
The vacuum pump is intended for the fixation
of drillstands Compact and Large. The pump is
only designed for sucking in air, and no other
gases or fluids.
For damage caused by usage other then
intended, the user is responsible.
RODIA ® 130/164/300
22

BEFORE USE

When drilling through walls or
floors, make absolutely sure that
there are no obstacles in the adjoin-
ing rooms and cordon off the build-
ing site. Prevent the drilling core
from falling.
Always use the correct supply volt-
age: The power supply voltage must match
the information quoted on the tool identifica-
tion plate.

INITIAL OPERATION

Functional test for the PRCD protec-
tive switch 4
WARNING: The ON/OFF switch 2
must be switched off, in order to
avoid unintentional starting of the
machine when carrying out the func-
tional test of the PRCD protective
switch 4.
Before commencing work, check that the
PRCD protective switch is functioning properly:
• Press the «ON» button on the PRCD protec-
tive switch. The red control lamp indicates
when the protective switch is ready for
operation.
• Press the «TEST» button. The control lamp
must go off.
Setting the speed range
CAUTION: Actuate the gear selector
switch only when the machine is at a
standstill.
The gear selector switch allows for pre-selec-
tion of three speed ranges.
Position •: low speed
Position ••: medium speed
Position •••: high speed