Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
GB
•
Hold the machine as rigidly as possible.
Always use the grip 5 at the front of the
•
machine.
•
Start drilling by keeping the machine at a
slight angle.
•
After the bit is guiding itself into the mate-
rial, swivel back the machine into the right
angle position.
WARNING: The machine has a very
high torque, especially in the first
gear. Therefor drill only extremely
concentrated, especially when work-
ing in first gear and with diameters
of more than 60 mm. In case of sud-
den blocking of the core bit the
machine, despite the safety clutch,
might get out of control and hurt you
considerably.
DRILLING WITH A DRILL
STAND
Guide block setting
A
B
When using a drill stand a right setting of
the guide block is required. Guide blocks for
Rodia core drilling machines features slide
strips for fine tuning on the drill stand.
•
Loosen the safety nuts (A) using the sup-
plied wrench 13.
•
Adjust the bolts (B) for an flexible sliding of
the guide block on the drill stand.
•
Secure then the bolts with the safety nuts
(A).
RODIA
®
130/164/300
24
Using Quick Release Guide Rodia
300
You can easy release the core drilling machine
Rodia 300 from its Quick Release Guide and
so from the drill stand.
Loosen the guide block safety bolt 36 with
•
the feed lever 13.
•
Pull the machine safety lock.
•
Slide the core drilling machine gently from
the guide block.
•
When replacing the machine secure
accordingly.
Aligning the drill stand
•
Set up the drill stand at the drilling loca-
tion.
Pull the safety bolt 22 and rotate the cen-
•
tering plate 23 forwards, until it snaps in.
•
Align the drill stand in such a manner that
for the used machine the tip of the center-
ing plate is located directly above the
required drilling location.
•
Fasten the drill stand.
Setting the drilling angle
Loosen the clamping lever 17.
•
Push in or pull out the rod 15 until the
•
desired drilling angle is shown on the
scale.
Tighten the clamping lever 17.
•
Drilling
•
Always ensure a adequate anchorage in
the underground.
Open the water tap 7.
•
Publicité
Table des Matières
