Special Tools Safety Warnings - Rodia 130-H Manuel D'utilisation

RODIA
ing and gloves away from moving parts.
Loose clothes, jewellery or long hair can
be caught in moving parts.
g) If devices are provided for the connection
of dust extraction and collection facilities,
ensure these are connected and properly
used. Use of dust collection can reduce
dust-related hazards.
4) Power tool use and care
a) Do not force the power tool. Use the cor-
rect power tool for your application. The
correct power tool will do the job better
and safer at the rate for which it was
designed.
b) Do not use the power tool if the switch
does not turn it on and off. Any power tool
that cannot be controlled with the switch is
dangerous and must be repaired.
c) Disconnect the plug from the power source
and/or the battery pack from the power
tool before making any adjustments,
changing accessories, or storing power
tools. Such preventive safety measures
reduce the risk of starting the power tool
accidentally.
d) Store idle power tools out of the reach of
children and do not allow persons unfamil-
iar with the power tool or these instructions
to operate the power tool. Power tools are
dangerous in the hands of untrained users.
e) Maintain power tools. Check for misalign-
ment or binding of moving parts, break-
age of parts and any other condition that
may affect the power tool's operation. If
damaged, have the power tool repaired
before use. Many accidents are caused by
poorly maintained power tools.
f) Keep cutting tools sharp and clean. Prop-
erly maintained cutting tools with sharp cut-
ting edges are less likely to bind and are
easier to control.
g) Use the power tool, accessories and tool
bits etc. in accordance with these instruc-
tions, taking into account the working
conditions and the work to be performed.
Use of the power tool for operations dif-
ferent from those intended could result in a
® 130/164/300
5) Service
a) Have your power tool serviced by a
b) For power tools with type X attachment,
SPECIAL TOOLS SAFETY
WARNINGS
NOTE: The above warning applies only to
impact drills and may be omitted for drills
other than impact drills.
Cutting accessory contacting a "live" wire may
make exposed metal parts of the power tool
"live" and could give the operator an electric
shock.
19
hazardous situation.
qualified repair person using only identical
replacement parts. This will ensure that the
safety of the power tool is maintained.
where a specially preparde cord is
needed to replace the cord: if the supply
cord of this power tool is damaged, it must
be replaced by a specially preparded
cord available through a qualified service
facilty.
Wear safety glasses and ear
protectors when impact drill-
ing.
Exposure to noise can cause hearing
loss.
Use auxiliary handle(s), if supplied
with the tool.
Loss of control can cause personal
injury.
Hold power tool by insulated grip-
ping surfaces, when performing an
operation where the cutting accesso-
ry may contact hidden wiring or its
own cord.
GB