Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
RODIA
Switching On/Off
Switching on: Press the ON/OFF switch
2 (position "1").
Switching off: Press the ON/OFF switch
2 (position "0").
WARNING: Use Rodia 130-H/-P
only in combination with a drillstand
when drilling in first gear, Position 1
(low speed).
Overload Protection
The LED 1 indicates the motor load, whereby
the following conditions are distinguished:
Blue:
No load
Green:
Regular drilling load
Red:
Overload
Excessive overloading the motor will reduce
the speed 6 times electronically to warn the
operator. The motor switches off automatically
and can immediately be switched back on
again.
Connecting the water feed
Close the water tap 7.
•
•
Connect the water feed hose to the water
tap or the water pressure tank.
•
When using the water pressure tank, make
sure that there is sufficient pressure when
working.
Check the waterflow indicator 3.
•
Mounting the drill bit 31
•
Clean and grease the thread on the drill
bit 31 and the tool holding fixture 6.
Screw a core bit 31 onto the tool holder
•
6 and tighten.
Removing the drilling core
•
Break off the drilling core and remove.
HAND HELD DRILLING
WARNING: Hand held drilling only
for Rodia 130-H/-P. Maximum bit
diameters:
®
130/164/300
•
•
Hand held wet drilling
•
•
•
•
•
Hand held dry drilling
Mounting the dry drilling kit 10
A
•
•
•
•
•
•
Using the dry drilling kit 10
•
23
Wet drilling in concrete: Ø 40
mm.
Dry drilling in masonry: Ø 164
mm.
For wet drilling open the water valve 7
and switch on the machine 2.
Hold the machine as rigidly as possible.
Always use the grip 5 at the front of the
machine.
Start drilling by keeping the machine at a
slight angle.
After the bit is guiding itself into the mate-
rial, swivel back the machine into the right
angle position.
B
Loosen the frontgrip 5 of the core drilling
machine.
Mount part A of the dry drilling kit onto the
drill spindle 6.
Slide the dry drilling sleeve (B) on part
A in the desired position for the vacuum
cleaner.
Tighten the grip 5.
Mount the hose of a industrial vacuum
cleaner on the sleeve (B).
Mount a core drill 31 onto the drill spindle
6.
Drilling is only possible if the masonry is
absolutley dry. Use a powerful industrial
dust exhauster. Change the filter regularly,
there is risk of obstruction.
GB
Publicité
Table des Matières
