Handling - SIKA P 700.3 Notice D'utilisation

Hand test pump
 8. Connect the pressure hose to the hand pump's MINIMESS
connection.
 9. Tightly screw the MINIMESS
 10. Select the suitable adapters and seals for the test item's connection.
 11. Screw the adapter for the test sample onto the MINIMESS
 12. Turn the test sample with seal in the adapter.
IMPORTANT! Do not yet tighten the test item!
 13. Now pump until the hydraulic liquid escapes at the test sample's connection. The pres-
sure hose and the test sample connection are now ventilated.
IMPORTANT! Demineralised water!
During the quality inspection of the hand pump, a functional test is carried out with de-
mineralised water. The reservoir may therefore contain residues of this liquid.
 Check the compatibility with your application and remove the residue using appropri-
ate measures (e.g. rinsing out with the hydraulic liquid).
5

Handling

Adhere to the following safety instructions when operating the hand pump:
CAUTION! Crushing hazard!
During the pumping procedure ensure that fingers or other body parts are kept away
from the area between the hand grips and the piston rod.
CAUTION! Material damage to valve stop!
If put under too much strain the stop and the hand pump will be damaged.
 Only continue to tighten the valves (the fine adjustment and pressure relief valves) by
hand, once the stop has been reached.
Before creating pressure consider:
Before you create pressure with the hand pump you should check for the following require-
ments:
 The reference gauge is connected to the hand pump.
 The test item is joined to the pressure hose with the correct adapters and seals.
 All pressure connections are correctly in place, so that they resist pressure.
 The hand pump, the pressure hose and the test sample have been properly ventilated
( § 4).
Technical changes reserved
®
adapter on the pressure hose.
®
connection, and tighten the
®
adapter.
Handling
- 31 -