SIKA P 700.3 Notice D'utilisation page 27

Hand test pump
SIKA provides support for the use of its products either personally or via relevant literature.
The customer verifies that our product is fit for purpose based on our technical information.
The customer performs customer- and application-specific tests to ensure that the product
is suitable for the intended use. With this verification all hazards and risks are transferred to
our customers; our warranty is not valid.
Qualified personnel:
The personnel who are charged for the installation and operation of the hand pump must
hold a relevant qualification. This can be based on training or relevant tuition.
The personnel must be aware of this operating manual and have access to it at all times.
General safety instructions:
In all work, the existing national regulations for accident prevention and safety in the
workplace must be complied with. Any internal regulations of the operator must also be
complied with, even if these are not mentioned in this manual.
Never use the hand pump together with an external pressure source. Do not attach an ex-
ternal pressure generator to the hand pump.
Do not use brake liquid or other aggressive media.
Hydraulic oils may cause irritation in case of skin contact.
 Take suitable protective measures to avoid skin contact.
 Observe the manufacturer's operating manual or the safety data sheet.
Do not remove any attached components (test item, pressure hose, reference gauge)
when the hand pump is under pressure:
 Open the pressure relief valve before removing any of the components.
Do not use Teflon tape to seal the pressure connections. Surplus Teflon tape can enter
the hand pump and damage it.
 Only use adapters and seals that are available as accessories.
Non-pressurised storage: Only store the hand pump with the pressure relief valve open.
This ensures that no pressure can be built up by unintentional pumping movements.
Avoid external force of all kinds towards the hand pump and its operating elements.
Do not use the hand pump if it is damaged or defective.
Special safety instructions:
Warnings that are specifically relevant to individual operating procedures or activities can be
found at the beginning of the relevant sections of this operating manual.
Technical changes reserved
Safety instructions
- 27 -