Basic Functions; Switching On The System - Nolan nCOM intercom Sécurité Et Instructions D'utilisation

NOLAN nCOM intercom 0025
Passenger's helmet
- Fit the helmet with the Basic Kit specific for the helmet (see instructions supplied with the Basic Kit).
- Insert the basic electronic card in its housing under the protection cover (see specific instructions supplied with the
Basic Kit).
- Connect the Pilot's helmet to the passenger's helmet using the Intercom wire as follows (fig. 8):
• connector 1 in the small jack (diameter 2.5 mm) of the pilot's helmet
• connector 2 in the large jack (diameter 3.5 mm) of the passenger's helmet
FIG. 8
1

4. BASIC FUNCTIONS

All functions available on the N-Com system can be turned on using 3 keys: "
command is confirmed by a special acoustic signal, depending on the requested function. This means that you can use all
the functions while wearing your helmet.

4.1. Switching on the system

- Insert the Intercom e-box in the relevant housing on the helmet.
- Press the "on" key and keep it pressed for 2 seconds until the LEDs turn on and you hear a buzz in the earphone.
- Release the key.
- The "on" key LED starts to flash slowly. When the system is turned on, it automatically opens the intercom communication.
23-05-2006 16:22 Pagina 24
2
24
ENGLISH
L L M M
", "on" and " "located on the e-box. Each