Nolan nCOM intercom Sécurité Et Instructions D'utilisation page 23

NOLAN nCOM intercom 0025
equipped with the battery will be the Pilot's helmet, and it will also be the one fitted with the e-box.
- After positioning the Basic Kit inside the helmet, apply the adhesive sealing trim around the 10-way connector as follows:
• Remove the N-Com protection cover from the helmet (fig. 2)
• Remove the protective film from the gasket
• Apply the sealing trim around the 10-way connector as shown in figure 3 and 4
- Insert the e-box in its compartment (fig. 5). First insert the front part, then press down on the e-box until both fasteners
click (fig. 6). To remove the e-box, operate at the same time on both sliding hooks until the e-box is ejected (fig. 7).
Warning: Do not leave the helmet exposed to atmospheric agents without the e-box or the protection cover supplied with
the helmet.
FIG. 2
FIG. 5
23-05-2006 16:22 Pagina 23
FIG. 3
FIG. 6
23
ENGLISH
FIG. 4
FIG. 7