Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Anleitung HKS 55 -4 sprachig
13.11.2001 13:38 Uhr
1
Adjustment of the cutting angle
1. Release the lock screws 1
2. Adjust the shoe to the desired angle between 0 and 45°.
3. Tighten the lock screws 1.
1
2
Adjustment of the splitter
1. Open the hinged guard hood and hold.
2. Release screws 1.
3. Adjust splitter 2 and tighten again.
Seite 9
Switching on
Important!
Pull out the plug before
Before pressing the On/Off
making any changes to the
switch, check that the saw blade
circular saw!
is properly fitted, that the moving
parts run smoothly and that the
clamping screws are tight.
1
3
4
2
Changing the saw blade
1. Open the hinged guard hood 1 and hold.
2. Hold up flange 4 using the pin-type wrench 2.
3. Apply socket wrench 3 and release screw.
4. Remove the flange 4 and saw blade by dropping
downwards.
5. Clean the flange and insert a new blade. Note the direction
5.
of rotation (see arrow on the guard hood).
6. Tighten the head bolt and check for concentricity.
Switching on and off
To switch on:
Press the lock button 3 and the button 4
simultaneously.
To switch off:
Release the lock button 3 and the button 4
3
4
GB
9
Publicité
Table des Matières
