Guide Bar Maintenance - Homelite HCS1835T Manuel D'utilisation

EN
FR DE ES
o The chain brake (2) is pushed forward
o The chain saw is switched off by releasing the
trigger (6)
When the chain brake (2) is engaged, the chain saw
cannot be started.
Transporting the chain saw
Before transporting the chain saw, always remove
the plug from the power socket and slide the chain
cover over the bar and chain. If several cuts are to be
performed with the chain saw, the saw must be switched
off between cuts.
Guide bar cover (Fig. 1)
The chain cover must be clipped onto the chain and bar
as soon as the sawing work has been completed and
whenever the machine has to be transported.
Sharpening the saw chain
When the chain penetrates into wood with difficultly, it
needs sharpening as follows:
Put the chain under tension.
Fasten the bar in a vice so that the chain can slide.
Fasten the file to the file holder and place it on cutter
at a 35° angle.
File with forward strokes only until all the worn out
part of the cutting edge is taken away.
Count the number of strokes given to the cutter
taken as a reference basis and file away for the
same number of strokes on all other cutters.
If after sharpening a few times, the depth gauge
protrudes from the template, you must reset its level
use a flat file.
Finally, round off the depth gauge.
NOTE: We advise you to have the deep or important
sharpening carried out by a service agent who is
equipped with electric sharpener.

GUIDE BAR MAINTENANCE

When you have finished working, clean out the
groove and the oil passages, with a scraping hook.
Periodically trim the sides of rails using a flat file.
If not done in the long run, the featheredges might
break away and damage the bar.
If one rail is higher than the other one, it is necessary
to make it even with a flat file and then smooth them
with a file or fine grain abrasive paper.
IT PT NL SV DA
English(Original instructions)
NO FI HU CS RU
DISPOSAL
Power tools and accessories contain large amount of
valuable resources and plastics that can be recycled.
Waste electrical products should not be disposed of
together with household waste. Please recycle where
facilities exist. Check with your local authority or retailer
for recycling advice.
20
RO PL SL HR ET LT LV SK BG