Ingeteam NEO Pro Manuel D'installation Et Usage page 15

Installation
1. Select the circuit on which you wish to install the CURVE device.
At the meter output
PANEL
Home power
CURVE
METER
Contracted
power
Electric
vehicle
PANEL
power
CAUTION
The operation of the CURVE device is independent of the direction of the active phase current that passes
through it.
2. Install the CURVE device in the active phase of the circuit you wish to measure (general or home).
Cables that connect to the charger
3. Attach the CURVE device to the cable using the mounting flange.
4. Run a 1.5 mm two-wire cable between the CURVE device and the charger.
ABV2012IQM01_ - Installation and Operation Manual
Mounting flange
Bypassing the home
PANEL
CURVE
Home power
METER
Contracted
power
Electric
vehicle
PANEL
power
Active phase
Ingeteam
EN
ES
FR
IT
15