Publicité
Les langues disponibles
Les langues disponibles
2
Dust which occurs during your work is hazardous to health. That is why it is
advisable to use a deduster (Dust class M) and to wear a dust mask on dry
drilling. As a suitable wet/dry deduster, our DSS 35 M iP is available as
add-on. The use of a dedusting system is also a prerequisite for optimal
cutting performance of the bit.
Mark the position and diameter of the desired hole, as shown below. When
drilling, make sure that the drill bit drills exactly in the middle of the marked
square.
Actuate the spindle stop and keep it
pressed.
The drilling spindle has a right-hand thread.
1
To ease screwing on and off, always use a
SW 18 open-end wrench at the drilling
spindle.
Never use a hammer, because this may
damage both the drill bit and the tool.
In order to check whether the spindle stop is
released before you switch on the tool, turn
the spindle slightly.
Let the machine run for a short period of
time and in a safe position. If the machine
does
immediately.
Drilling
An LED lamp is fitted on the handle for a
better view of the drill hole - see arrow.
You should switch this on for drilling and
switch it off again after drilling
(batteries: 3xLR44)
not
run
easily,
17
stop
working
Publicité
