Publicité
Les langues disponibles
Les langues disponibles
During manual operation, always hold the tool with both hands
and be fall-safe. Consider the tool's reaction torque in case of
blocking.
Always work with concentration. Always work in a carefully
considered way and do not use the tool if you are lacking
consideration.
Hold power tool by insulated gripping surfaces, when
performing an operation where the cutting accessory may
contact hidden wiring or its own cord.
contacting a "live" wire may make exposed metal parts of the power
tool "live" and could give the operator an electric shock.
For further safety instructions, see the enclosure.
The EFB 68 is designed according to protective class II. Prior to putting the
tool into operation, check the mains voltage for conformity with the
requirements of the tool's nameplate. Voltage variations between + 6 % and
– 10 % are permissible. The tool includes a start-up speed limiter to prevent
fast expulsion fuses from unindented responding. Only use extension
cables with a sufficient cross-section. A cross-section which is too small
could cause a considerable drop in performance and an overheating of
machine and cable.
Switching ON and OFF
Short-Time Operation
Switching-on: Depress switch rocker at back
(1), then push forwards (2) and
hold.
Switching-off: Release the
switch rocker.
Permanent Operation
Switching-on: Depress switch rocker at back
(1), then press forwards (2) and
engage by pressing on the front
end (3).
Switching-off: To switch off the power tool,
release the switch rocker by
Electrical Connection
15
Cutting accessory
2
3
1
4
Publicité
