shark ION F80 Guide D'utilisation page 3

3
(Click)
2
(Click)
1
(Click)
1. Insert wand into floor nozzle.
2. Insert handheld vacuum into wand.
3. Insert battery into handheld vacuum.
For proper operation, ensure all components are firmly connected.
s h a r kc l e a n . c o m
ASSEMBLY YOUR ION POWER PACK BATTERY
Your ION Power Pack Battery does not come fully charged. Prior to first use, charge completely. During first
use, discharge fully to condition your ION Power Pack Battery. Failure to do so may cause LED indications to
work incorrectly.
RECYCLING THE ION POWER PACK BATTERY
When your ION Power Pack Battery needs to be replaced, dispose of it or recycle it in accordance with local
ordinances or regulations. In some areas, it is illegal to place spent lithium-ion batteries in the trash or in a
municipal solid waste stream. Return spent power packs to an authorized recycling center or to retailer for
recycling. Contact your local recycling center for information on where to drop off the spent power pack.
RUNTIMES PER FULLY-CHARGED BATTERY
MODE AND SETTINGS
HANDVAC ONLY
BARE FLOOR (Wand/Nozzle Connected)
CARPET (Wand/Nozzle Connected)
NOTE: See enclosed Quick Start Guide for number of ION Power Pack batteries included with your vacuum.
LED BATTERY POWER AND CHARGING INDICATORS
NOTE: A complete charge takes approximately 3.5 hours. The ION Power Pack, like all lithium-ion products, will naturally
decrease in capacity over time from the 100% capacity of a new battery.
s h a r kc l e a n . c o m
ION POWER ION BOOST
Up to 40 Minutes Up to 12 Minutes
Up to 32 Minutes Up to 11 Minutes
Up to 26 Minutes Up to 10 Minutes
Charging
Low Mid
Charge Charge
Nearly Full
Full Charge
NOTE: Full charge takes approximately 3.5 hours.
In Use
Full Mid
Charge Charge
Nearly No
Empty Charge
Low
Charge