shark ION F80 Guide D'utilisation page 7

MAINTAINING YOUR VACUUM
ACCESSING BRUSHROLLS
Open the brushroll garage by sliding back the release
buttons. To close, insert the tabs on the lid into the
slots on the nozzle, then press down both sides.
To close the garage door lid, insert the tabs on the
lid into the slots on the nozzle, then press down on
both sides of the lid until it clicks securely into place.
NOTE: If the headlights are flashing, the brushroll
garage lid is not clicked securely into place on both
sides. The lights will flash and the brushrolls will not
spin until both sides of the lid are securely clicked
into place.
s h a r kc l e a n . c o m
CLEANING BRUSHROLLS
BRUSHROLL
Run scissors along the guide on the brushroll
to remove any string, hair, or debris.
SOFT ROLLER
Pull out roller by the tab. Remove any string, carpet
fibers, or hair, and remove debris from the roller
housing. Wash the roller as needed, using only
water. Air-dry completely for at least 24 hours
before reinserting.
Reinsert roller by sliding it into the front of the
floor nozzle until it clicks into place.
MAINTAINING YOUR VACUUM
CHECKING FOR BLOCKAGES
Turn off vacuum and remove battery.
Remove the handheld vacuum from the wand
and check all intake openings to the dust cup.
Turn off vacuum and remove battery.
Remove the hand vacuum and floor nozzle from the wand
and check the wand for blockages.
Turn off vacuum and remove battery.
Remove the floor nozzle from the wand. Tilt neck of floor
nozzle back to straighten the airway to remove blockages.
s h a r kc l e a n . c o m