Maintenance Schedule; Refueling; Engine Oil - Honda GC160 Manuel De L'utilisateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

• Read the instructions before you begin, and make sure you have
the tools and skills required.
• To reduce the possibility of fire or explosion, be careful when
working around gasoline. Use only a nonflammable solvent, not
gasoline, to clean parts. Keep cigarettes, sparks and flames away
from all fuel related parts.
Remember that an authorized Honda servicing dealer knows your
engine best and is fully equipped to maintain and repair it.
To ensure the best quality and reliability, use only new genuine Honda
parts or their equivalents for repair and replacement.

MAINTENANCE SCHEDULE

Perform at every
indicated month or
ITEM
operating hour interval,
whichever comes first.
Check

Engine oil

Change
Check
Air filter
Clean
Replace
Check-adjust
Spark plug
Replace
Spark arrester
Clean
Idle speed
Check-adjust
Fuel tank and filter
Clean
Fuel tube
Check
Valve clearance
Check-adjust
Combustion chamber Clean
(1) Service more frequently when used in dusty areas.
(2) Change engine oil every 25 hours when used under heavy load
or in high ambient temperatures.
(3) These items should be serviced by an authorized Honda
servicing dealer, unless you have the proper tools and are
mechanically proficient. Refer to the Honda shop manual for
service procedures.
(4) For commercial use, log hours of operation to determine proper
maintenance intervals.
Failure to follow this maintenance schedule could result in non-
warrantable failures.

REFUELING

Use unleaded gasoline with a pump octane rating of 86 or higher. This
engine is certified to operate on unleaded gasoline. Unleaded
gasoline produces fewer engine and spark plug deposits and extends
exhaust system life.
 WARNING
Gasoline is highly flammable and explosive, and you can
be burned or seriously injured when refueling.
• Stop engine and keep heat, sparks, and flame away.
• Refuel only outdoors.
• Wipe up spills immediately.
NOTICE
Fuel can damage paint and some types of plastic. Be careful not to
spill fuel when filling your fuel tank. Damage caused by spilled fuel is
not covered under the Distributor's Limited Warranty (see page 11).
Never use stale or contaminated gasoline or oil/gasoline mixture.
Avoid getting dirt or water in the fuel tank.
E
REGULAR SERVICE PERIOD (4)
Before
First
Every 3
Every 6
Every
Each
Month
Months
Months
Year
Use
or
or
or
or
5 Hrs
25 Hrs
50 Hrs
100 Hrs
O
O
O (2)
O
O (1)
O
O
O(3)
O(3)
Every 2 years
(Replace if necessary) (3)
O(3)
After every 250 hours (3)
1. Remove the fuel tank
cap.
2. Add fuel to the bottom
of the fuel level limit in
the neck of the fuel
tank. Do not overfill.
Wipe up spilled fuel
before starting the
engine.
ENGINE OIL
Recommended Oil
Use 4-stroke motor oil that meets
Every
or exceeds the requirements for
Page
Two
Years
API service classification SH, SJ,
or 250
or equivalent. Always check the
5
API service label on the oil
container to be sure it includes the
5
letters SH, SJ, or equivalent.
6
SAE 10W-30 is recommended for general use. Other viscosities
O
shown in the chart may be used when the average temperature in
your area is within the indicated range.
6
O
Oil Level Check
6
Shop
1. Check the oil with the engine stopped and level.
manual
Shop
2. Remove the oil filler cap/dipstick and wipe it clean.
manual
Shop
3. Insert the oil filler cap/dipstick into the oil filler neck as shown, but
manual
do not screw it in, then remove it to check the oil level.
Shop
manual
4. If the oil level is near or below the lower limit mark on the dipstick,
Shop
fill with the recommended oil to the upper limit mark (bottom edge
manual
of the oil fill hole). Do not overfill.
5. Reinstall the oil filler cap/dipstick.
Oil Change
Drain the engine oil when the engine is warm. Warm oil drains quickly
and completely.
1. Place a suitable container
next to the engine to catch
the used oil.
2. Remove the oil filler cap/
dipstick, the oil drain plug
and washer.
3. Allow the used oil to drain
completely, then reinstall
the drain plug and new
washer. Tighten the drain
plug securely.
Please dispose of used
motor oil in a manner that is compatible with the environment. We
suggest you take used oil in a sealed container to your local
recycling center or service station for reclamation. Do not throw it
in the trash or pour it on the ground or down a drain.
AMBIENT TEMPERATURE
OIL FILLER CAP/
DIPSTICK
UPPER LIMIT
OIL FILL HOLE
LOWER LIMIT
(bottom edge)
MAXIMUM
FUEL LEVEL
OIL FILLER
CAP/
DIPSTICK
DRAIN
PLUG
SEALING
WASHER
5

Hide quick links:

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Gc190

Table des Matières