Storage; Ordering Accessories; Guarantee And Support; Frequently Asked Questions - Philips SCD570 Manuel D'installation

10 Storage

If you are not going to use the baby monitor for
some time, do the following:
•
Remove the non-rechargeable batteries from
the baby unit.
•
Remove the rechargeable batteries from the
parent unit.
• Store the parent unit, the baby unit and the
adapters in a cool and dry place.

11 Ordering accessories

To buy accessories or spare parts, visit
www.shop.philips.com/service or go to your
Philips dealer. You can also contact the Philips
Consumer Care Centre in your country (see the
worldwide guarantee leaflet for contact details).
12 Guarantee and
support
If you need information or support, please visit the
Philips website at www.philips.com/support
or read the separate worldwide guarantee leaflet.
13 Frequently asked
questions
This chapter lists the questions most frequently
asked about the appliance. If you cannot find the
answer to your question, visit www.philips.com/
AVENT for more frequently asked questions
or contact the Consumer Care Center in your
country.
18
Why don't the power-on light of the baby unit
and the 'link' light of the parent unit come on
when I press the on/off buttons of the units?
• Perhaps the rechargeable batteries of the
parent unit are empty and the parent unit is
not plugged in. Connect the parent unit to an
electric outlet. Then press the on/off button to
establish connection with the baby unit.
• Perhaps the baby unit is running on battery
power and its non-rechargeable batteries are
empty. Replace the non-rechargeable batteries
or connect the baby unit to an electric outlet.
Then press the on/off button to establish
connection with the parent unit.
• If the 'link' light on the parent unit still does not
start flashing red, use the reset function to reset
the units to their default settings.
Why does the 'link' light on the parent unit flash
red continuously and why is the message 'NOT
LINKED' or 'LINKING' shown on the display?
• The baby unit and the parent unit are out
of range of each other. Move the parent unit
closer to the baby unit.
• The baby unit may be switched off. Switch on
the baby unit.
Why does the battery status light on the baby
unit flash red?
• The non-rechargeable batteries of the baby unit
are running low. Replace the non-rechargeable
batteries or connect the baby unit to an electric
outlet.
Why does the parent unit beep?
• If the parent unit beeps while the 'link' light
flashes red continuously and the message 'NOT
LINKED' or 'LINKING' is shown on the display,
the connection with the baby unit is lost. Move
the parent unit closer to the baby unit or switch
the baby unit on, if it was off.
• If the parent unit beeps and the battery symbol
on the display is empty, the rechargeable
batteries of the parent unit are running low.
Recharge the batteries.