Delay Start; Auto Power Off - Gaggenau DF 260 Notice D'utilisation

Delay start

You can delay the start of the program in 1-hour steps up to 24 hours.
• Open the door. Power on the unit.
• Press "C" button until the timer programming display jumps to 01 .
• Press + or – button until the displayed time corresponds with your requirements.
• Press START button. Delay start is activated.
To cancel delay start:
• Press the + or – button until "00" is indicated on the digital display.
You can change your program selection at any time until the program starts.
• Close the door
Cycle Completion Signal
The cycle completion is also indicated by a tone.This function can be changed as follows:
• Open the door. Power on the unit.
• Hold down "A" button and press START button until the display shows H:00.
• Release both buttons.
• Press "A" until the display shows "b:02".
• Press "C" to increase or decrease the tone.
• b:00 = Off and b:03 = loudest
• Press START button. The set value is saved.
• Close the door.
Intensive drying
The inal rinse uses a higher temperature which improves the drying result.
The running time may increase slightly. (Caution if utensils are delicate!)
• Open the door. Power on the unit.
• Hold down "A" button and press START the digital display shows "H:00".
• Release both buttons.
• Press the "A" button until the display indicates "d:00".
• Press the "C" button to turn intensive drying on or off. "d:01" = ON or "d:00" = OFF
• Press START button. The set value is saved.
• Close the door.

Auto Power Off

To save energy, the dishwasher is turned off 1 minute after the wash cycle ends. Auto Power Off can be
adjusted from P:00 to P:02.
To change the factory setting (P:01):
• Open the door. Power on the unit.
• Hold down "A" button and press START button until the display shows H:00.
• Release both buttons.
• Press the "A" button until the display indicates "P:01".
• Press the "C" button to change auto power off setting. "P:00" = dishwasher does not turn off
automatically, "P:01" = dishwasher turns off after 1 minute, "P:02" = dishwasher turns off after 120
minutes (2 hours)
• Press START button. The set value is saved.
• Close the door.
15