Preparing The Installation; Mounting The Loudspeaker - Bose Professional DesignMax DM6PE Notice D'installation

PRO.BOSE.COM

Preparing the Installation

Using a Safety Cable
Some regional construction codes require the use of a
secondary method of securing loudspeakers to support
structures to provide additional safety. Choose a mounting
position, method, and hardware consistent with local
building codes and regulations.
Bose recommends using (A) a safety wire or (B) a safety
cable as a secondary securing mechanism (not included).
See the diagram to the right for safety attachment points.
The included suspension cable can be used as a safety
cable when using the Threaded Rod Adapter or Pendant
Conduit Adapter accessories.
Follow the manufacturer's instructions for any secondary
securing mechanism implemented.

Mounting the Loudspeaker

Before beginning installation, be sure to adjust your loudspeaker tap setting.
1. Insert the included suspension cable through the cable fastener and wrap the cable around a support structure; secure the cable
using the cable fastener. Note: Arrows on the cable fastener indicate the cable direction.
A. To loosen the cable, insert the fastener tool into the release hole and adjust the cable.
2. Pull the loose end of the suspension cable to adjust the cable to the desired height.
3. Secure the cable clip to the center attachment point. Once you've reached the desired loudspeaker height, cutaway any excess cable.
Note: Trim any frayed filaments with wire cutters after cutting to length.
4. For installations where the loudspeaker may be exposed to water or condensation, insert the loudspeaker wiring through the rubber
conduit of the input cover (see Preparing the Input Cover on page 4).
Remove the connector, wire the connector, and reinsert the connector into the loudspeaker. For wiring information, see Wiring the
5.
Loudspeaker on page 4.
6. For installations where the loudspeaker may be exposed to water or condensation, place the input cover over the connector and press
it firmly against the loudspeaker until fully seated into the input cover cavity to create a tight seal.
Note: Be sure the loudspeaker wire reaches the bottom of the enclosure recess to prevent water from running down the loudspeaker
wire into the input cover.
Use the included cable ties to secure the wiring to the suspension cable.
7. Rotate the grille so the logo is in an orientation suitable for your installation.
Note: Do not remove the grille unless painting. Logo can be removed from the grille by peeling away from grille surface.
q
r
Installation Guide • DesignMax DM6PE
A
t
A B
w
y
Installation
e
u
English • 5