Loudspeaker Settings; Connection Diagrams - Bose Professional DesignMax DM6PE Notice D'installation

Setup
Preparing the Input Cover
The input cover is designed for three different wiring scenarios. To change the configuration of the input cover to support your wiring
scenario, cut along the perforation on the rubber conduit.
Note: Indoor-only applications do not require use of the input cover.
Single In
Note: If using the wide open rubber conduit configuration, it is the installer's responsibility to seal against water ingress into the Euroblock
connector. Use outdoor or marine-grade silicone to seal all wiring connections to ensure a tight seal.
Installation Options and Accessories
q
Threaded Rod Adapter
w
Pendant Conduit Adapter
Wiring the Loudspeaker
Wire Gauge
The DesignMax DM6PE loudspeaker is designed to work with 18
AWG (0.8 mm ) to 14 AWG (2.1 mm
2

Connection Diagrams

Expose six millimeters (1/4 inch) of bare wire to attach to the
terminals.
70/100V
8Ω
4 • English
) size wire only.
2
In and Out
q

Loudspeaker Settings

2.5W 5W
5W 10W
* Factory default
Transformer Tap Setting
Set tap by turning. Use a flat head screwdriver.
PRO.BOSE.COM
Wide Open
w
70V
10W 20W 40W
20W 40W 80W
100V
** NC: No Connection (do not use)
DesignMax DM6PE • Installation Guide
80W*
8Ώ
NC**