Installing And Removing Bits - Skil SD561201 Guide D'utilisation

Forward/Reverse Selector
The forward/reverse selector determines the
rotation direction of the tool and serves as the
on/off switch. With the tool held in the normal
operating position, as shown in Fig. 3:
a) To tighten a screw, rotate the forward/reverse
selector counterclockwise.
b) To loosen a screw, rotate the forward/reverse
selector clockwise.
c) To turn off the tool, release the forward/
reverse selector.
LED Worklights
Two LED worklights, located on the head of the tool, illuminate when the forward/reverse
selector is rotated. This provides additional light on the surface of the work piece for operation
in lower-light areas. The LED worklights will automatically turn off 8 to 12 seconds after the
forward/reverse selector is released.

Installing and Removing Bits

CAUTION
activate the forward/reverse selector when
installing or removing bits .
WARNING
damaged, missing, or loose parts, such as
screws, nuts, bolts, caps, etc. Tighten all
fasteners and caps securely and do not
operate this product until all missing or
damaged parts are replaced .
a) To install a screwdriver bit, push the black
sleeve backwards, install the bit into the collet,
and then release the black sleeve. Make sure
that the bit is firmly in place.
b) To remove a screwdriver bit, push the black sleeve backwards, pull the bit from the collet,
and then release the black sleeve.
14
To avoid possibly serious
injury, take care not to
Before each use, inspect
the entire product for
Fig. 3
Reverse
Forward
Fig. 4
1/4'' Hex Collet
Black Sleeve