Panasonic TY-FB12LC Mode D'emploi page 6

PJLink™ Protocol
The network function of the terminal board conforms with PJLink™ class 1 and you can operate the
following actions from your computer using PJLink™ protocol.
• Display setup
• Display status query
Supported commands
Commands to control the display with PJLink™ protocol are shown in the table below.
Command
POWR Power control
POWR? Power status query
INPT Input switch
INPT? Input switch query
AVMT Shutter control
AVMT? Shutter control query
ERST? Error status query
LAMP? Lamp status query
INST? Input switch list query
NAME? Projector name query
INF1? Manufacturer name query
INF2? Model name query
INFO? Other information query
CLSS? Class information query
PJLink™ security authentication
Set "Panasonic" for the PJLink™ password.
• PJLink™ is a pending trademark in Japan, the United States, and other countries or areas.
6
Control
Parameter
0 = Standby 1 = Power "On"
Parameter
0 = Standby 1 = Power "On"
Parameter
First byte: 1 (RGB) fixed
Second byte: Input position (from 1)
Parameter
10 = Picture On (picture mute deactivated), 11 = Picture Off (picture on mute)
20 = Audio On (audio mute deactivated), 21 = Audio Off (audio on mute)
30 = Shutter mode Off (picture and audio mute deactivated)
31 = Shutter mode On (picture and audio on mute)
Parameter
11 = Picture Off (picture on mute)
21 = Audio Off (audio on mute)
30 = Shutter mode Off (picture and audio mute deactivated)
31 = Shutter mode On (picture and audio on mute)
Parameter
First byte: Means fan error. 0 or 2.
Second byte: 0
Third byte: 0
Fourth byte: 0
Fifth byte: 0
Sixth byte: Means other error. 0 or 2.
Meaning of the 0 – 2 settings:
0 = Error is not detected, 2 = Error
Not supported
Parameter
11: Computer input
12 - 16: Slot 1 input (INPUT1A)
Slot 1 input (INPUT1B)
Slot 2 input (INPUT2A)
Slot 2 input (INPUT2B)
Slot 3 input (INPUT3)
Numbers greater than 12 are depending on the slot installation condition
Returns empty character (no name information)
Returns "Panasonic"
Returns "TH-65PF12" (for 65-inch model)
Returns version number
Returns "1"
Remark