Maxi-Cosi Loola 01401 Mode D'emploi page 5

4
Seat Pad
1. Open seat by pulling sides outward.
2. Release shoulder restraint straps
from buckle (Figure 4).
3. Access back of seat as shown and
push shoulder strap anchors through
seat to release them (Figure 4a).
NOTE: Rotate anchors 90° to pass
through seat.
4. Feed crotch strap and buckle
through slot in seat pad (Figure 4b).
5. Remove shoulder pads. Feed shoulder
strap anchors through waist slots.
Reinstall shoulder pads then feed
straps through desired shoulder slots
(Figure 4b). Feed straps through the
corresponding holes in seat. Pull on
shoulder straps to ensure they are
secure. Twist straps to ensure they
lay flat.
6. Starting at the top, snap the seat pad
onto seat. The frame should go into
the pocket at the bottom rear of the
pad (Figure 4c). NOTE: There are a
total of ten snaps around the outside
of the frame and four snaps in the
inside of the seat.
WARNING:
• For proper installation of the restraint system, make sure both anchors lay flat
against the back board.
• NEVER use stroller without BOTH restraint and crotch straps.
Assembly
3
4
4b
Anchors
4a
4c