Adding Delays; Adding Reverb - Bose T4S ToneMatch Notice D'utilisation

Operation

Adding Delays

The Delay function allows you to apply a digital-, analog-, or tape-style delay.
Note: To bypass the Delay settings, press the Type control. Press it again to activate.
Rotate the Type control to access the list of Delay types and highlight your choice.
1.
A. Digital Delay – Straight digital delay effect where the repeats remain uncolored. Features adjustable
mix, time, and feedback parameters. Works well with guitars, drums, and vocals.
B. Analog Delay – Classic analog delay effect where the repeats continuously deteriorate. Features
adjustable mix, time, and feedback parameters. Works well with guitars, drums, and vocals.
C. Tape Delay – Vintage-style tape delay effect where the repeats deteriorate even more than Analog
Delay. Well-suited for guitars, horns, harmonica, and vocals.
Press the Select control to select your choice, or press the Cancel control to exit the list with no change.
2.
3. Rotate the Time control to adjust the amount of the delay time in 5 ms increments. Press the Time control
to tap your desired delay tempo.
4. Rotate the Mix control to set the desired mix of dry signal (0%) to wet signal (100%).
5. Press the Mix control to access the Fdbk. setting. Rotate the Fdbk. control to adjust the amount of delay
feedback.

Adding Reverb

The Reverb function applies a user-adjustable amount of reverb to the selected channel. To select the type of
reverb, see "Selecting a Reverb Type" on page 27.
Note: To mute the Reverb effects, press the Mix control. Press it again to unmute.
1. Press or rotate the Menu control and select which output to send the reverb too.
2. Rotate the Mix control to adjust the desired mix of dry signal (0%) to wet signal (100%).
Rotate the Bright control to equalize the high frequencies of reverb applied to the selected channel.
3.
26 - English
Ch 1 Delay
Fdbk.
Type Time Mix
Digital 250ms 30%
Ch 1 Reverb
Menu Mix Bright
Main 50% 50%