Mounting Options; Mounting The T4S/T8S On A Camera Tripod Stand - Bose T4S ToneMatch Notice D'utilisation

Mounting Options

The T4S/T8S comes with a 1/4" (6 mm) mounting screw insert. This enables it to be mounted onto a number
of available products that include a 1/4" (6 mm) mounting screw, including a camera tripod stand.

Mounting the T4S/T8S on a Camera Tripod Stand

1. Extend the camera tripod legs and secure at desired height.
2. Remove the bracket from the top of the camera tripod stand and secure the bracket to the bottom of the
T4S/T8S with the screw. Make sure the small indentation on the T4S/T8S and the bump on the bracket
are aligned. See Figure 6.
3. Secure the bracket with the T4S/T8S back onto the camera tripod stand. See Figure 8.
Figure 6. Securing bracket to T4S
Figure 7. Bracket attached to T4S
WARNING: Do not use the ToneMatch® T4S/T8S mixer with a tripod/stand that is unstable. The mixer
is only designed for use on a 1/4" screw (6 mm), and the tripod/stand must be capable of supporting
a device with a minimum weight of 1.9 kg (4.1 lbs) and an overall size of 214 x 311 x 83 mm (8.4 x 12.25
x 3.25 inches). Using a tripod/stand that is not designed to support the size and mass of the T4S/T8S
mixer may lead to an unstable and hazardous condition that could result in injury.
Figure 8. Mounting T4S to tripod stand using bracket
System Setup
English - 11