Advanced Settings - Riello UPS Sentinel Dual SDL 8000 Manuel D'installation Et D'utilisation

U
SE
FUNCTION
Alarm threshold
for maximum
load
Selects the level of
Display
brightness of the LCD
brightness
Selects the operating
Acoustic alarm mode of the acoustic
Selects the operating
Auxiliary socket
mode of the auxiliary
(power share)
Selects the allowed
input frequency range
for the passage onto
Input frequency
tolerance
synchronization of the
Selects the allowed
Bypass voltage
voltage range for the
thresholds
passage onto bypass
Selects the allowed
Bypass voltage
voltage range for
thresholds for
operation in ECO
ECO
Selects the sensitivity
Sensitivity of
of intervention during
intervention for
operation in ECO
ECO
Power supply of the
Power supply of
load on bypass with
the load in stand-
UPS switched off
by
Selects the mode of
Bypass operation
use of the bypass line
DESCRIPTION PREDEFINED
Selects the user
Disabled
overload limit
Maximum
display
alarm
Always
connected
socket

ADVANCED SETTINGS

bypass and for
output
Low:
High: 264V
Low:
High: 253V
mode
Normal
mode
Disabled (load
NOT powered)
(stand-by state)
Enabled /
High sensitivity
POSSIBLE CONFIGURATIONS
Disabled
0 ÷ 103 in 1% steps
Minimum ÷ Maximum in 20 steps
Normal
Low
Low: does not sound for momentary
bypass intervention
Always connected
Disconnection after n seconds of
operation from battery
Disconnection after n seconds from
the end of discharge prealarm signal
... (see the configuration software
manual)
± 0.25%
± 0.5%
± 5%
± 0.75%
± 1 ÷ ±10 in 1% steps
180V Low: 180 ÷ 200 in 1V steps
High: 250 ÷ 264 in 1V steps
200V Low: 180 ÷ 220 in 1V steps
High: 240 ÷ 264 in 1V steps
Low
Normal
High
Disabled (not powered)
Enabled (powered)
Enabled/High sensitivity
Enabled/Low sensitivity
Disabled with input/output
synchronization
Disabled without input/output
synchronization
76
MODE