Before Use; Assembly; Assembling The Welding Helmet; Inserting The Flux-Cored Wire - Parkside PFDS 33 B2 Instructions De Montage

- The work pieces should be prop-
erly earthed
- Devices and systems susceptible
to interference radiation should be
removed from the welding area if
possible or shielded.

Before Use

Remove all parts from the packaging and inspect
whether the flux-cored arc welding unit or the
individual parts are visibly damaged. If this is
the case, do not use the flux-cored arc welding
unit. Contact the manufacturer using the service
address stated.
Remove all protective film and other transport
packaging.
Check that all items included in the scope of
delivery are present.

Assembly

Assembling the
welding helmet
Insert the dark welding lens
with the writing to the top
The marking on the dark welding lens
be visible from the front of the welding helmet.
Push the handle
16
the mask from the inside until it clicks in (See
Fig. B).

Inserting the flux-cored wire

To prevent the hazard of an
electrical shock, injury or damage, pull the mains
plug from the socket before maintenance or prepar-
ing for work.
Note: Depending on the application, different
welding wires may be required. Welding wires with
into the mask
21
(see Fig. A).
22
must
21
into the suitable notch on
Safety instructions / Before Use / Assembly
a diameter from 0.6 – 0,9 mm can be used with this
unit.
The feed roller, welding nozzle and wire cross-section
must always be compatible.
The unit is suitable for wire reels up to a maximum
of 450g.
Unlock and open the cover for the wire feeder
unit by lifting the threaded rod up from the
1
slotted hole.
Unlock the roller unit by turning the roller
holder clockwise (see Fig. C).
25
Remove the roller holder
Fig. C).
C
25
Note: Please ensure that the wire end does not
loosen and that the roll does not automatically
roll away. The wire end may only be loosened
during assembly.
Unwrap the flux-cored wire welding coil
completely so that it can be unrolled freely.
However, do not loosen the wire end just yet
(see Fig. D).
Place the wire reel onto the shaft. Ensure that
the roll uncoils on the side with the wire outlet
(see Fig. D).
26
Reattach the roller holder
pressing on it and turning it counterclockwise
(see Fig. D).
from the shaft (see
25
18
and lock it by
25
GB/IE 37