Installation - Kemper KHS VAV-PLUS Instructions D'installation Et D'utilisation

2

Installation

Note!
The advice of system manuals
(e.g. LOGIC system control, KHS
Mini system control, Leak Pro-
Recommendations:
a) Quarter turn stop valve
It is recommended to install the quarter
turn stop valve PLUS in the pipeline in
advance without the servo drive to
b) Servo drive with spring reset
Note!
Before installing the servodrive,
make sure the home position is
set.
The servo drive is delivered in
position "OFF" (CLOSED).
1
Adjust servo drive
The servo drive has 8 alignment steps that
can be aligned in 45° steps. To do that, select
the appropriate servo drive position, depen-
ding on the amount of space.
16 / 52 – K410068601001-00 / 01.2021 – © www.kemper-olpe.de
tection System, KHS Timer-Set) in which the
valve is to be integrated, must be
observed.
protect the servo drive from being damaged
or getting dirty. Make sure the valve is instal-
led in the pipeline tension free.
2
Put on servo drive
Press the drive firmly onto the cone.