Tv Tuner Operation; Accessing Tv Mode; Seek Tuning; Direct Channel Selection - Jensen VM9511TS Guide D'instructions

TV TUNER OPERATION

Accessing TV Mode

To switch to TV mode, press the SRC button (15) on the front
panel or on the remote control (8) until "TV" appears at the
bottom of the screen.

Seek Tuning

Press the >>| button (19) on remote control, or the > button
on the joystick (17) to seek the next available TV station by
increasing the tuning frequency.
Press the |<< button (17) on the remote control, or the <
button on the joystick (16) to seek the next available TV
station by decreasing the tuning frequency.
Once a TV station is searched, the auto seeking stops and
the TV station is played. If no station is searched, the tuning
stops at the first channel after performing a round search.
Storing Stations (AS)
Auto Memory Tuning
To select the strong stations in the current TV frequency
range, press and hold the joystick button (20) to activate the
Auto-Store function. The new stations replace stations
already stored. Press the joystick button again or press the
/BAND button (18) on the remote control to stop searching.
Selecting a TV Station
To browse through stored stations:
• Press the >> button (14) on the remote control or the /\
button (18) on the joystick to tune to the next stored
station.
• Press the << button (22) on remote control or the V button
(19) on the joystick to tune to the previous stored station.

Direct Channel Selection

Use the numeric keypad on the
remote control (29) to enter a
specific TV station.

Display Current Channel

Press the INFO button (10) on the
remote control to display
information regarding the current
TV station.
32
VM9511TS