Si628 P (Panel Mount); Assembly - Hach LANGE si628 P Manuel D'utilisateur

3. Installation

3.2. si628 P (panel mount)

DANGER
Only qualified personnel should conduct the tasks described in this section of the manual.

3.2.1. Assembly

For the si628 P mounting a drill hole is required according to the diagram.
After putting the instrument in the panel, it must be fitted using two clamps as indicated in the figure.
21 mm
0.8 in
BNC connector
for electrode
Plug-in screw connector
10
si628 P_HACH_LANGE_Ed.0510.indd ANG:10 si628 P_HACH_LANGE_Ed.0510.indd ANG:10
92 mm
3.7 in
Drill hole
Panel
80 mm
3.1 in
Side view
Clamp to fix to the panel
7 mm
0.3 in
20/5/10 11:24:20 20/5/10 11:24:20