Condair RO Série Guide Rapide page 8

4.1.1 Water piping and connections
The following flow diagram shows the needed fittings and their placement for RO-HM. Please follow
the information strictly.
3/8" hose
[1]
[1]
The following flow diagram shows the needed fittings and their placement for RO-HB. Please follow the
information strictly.
3/8" hose
[1]
1
8
Installation Condair RO-H
3/8" hose
pure
water
Inlet
drain
Siphon (on site)
[3] [4]
RO-H
3/8" hose
Pure
Inlet
water
drain
Siphon (on site)
1. Inlet (3/8" push fit)
2. Pure water (3/8" push fit)
3
2
3. Drain (1/4" push fit)
[4]
[3]
1/4" hose
3/8" - 1/4"
push fit
connector
[4]
[8]
[5] [6]
[1] 1/2"male - 1/2" female connector
with 3/8" push on and manual valve
Tank fittings (SS parts need to be attached using Teflon tape):
1" fNPT Tee
1" mNPT – 3/8" fNPT Bushing
3/8" – 3/8" JG push fit adaptor (grey)
3/8" – 10mm JG push fit adaptor (black)
[6]
1/4" hose
[1] 1/2" male - 1/2" female connector
with 3/8" push on and manual valve
[3] 3/8" - 1/4" push fit connector
[4] 1/4" push fit equal tee
[5] Tank valve needs to be attached to
[5]
tank using Teflon tape.
[6] 1/4" push fit to 3/4" female thread
[8] 1/4" push fit manual flush valve with
manual valve
[7] [8]