Product Data - Condair RO Série Guide Rapide

7

Product Data

Technical parameters
Voltage / frequency; protection
Power Rating
Incoming water quality
Incoming conductivity (see page 12)
Incoming TDS
Incoming pressure (see page 12)
max. permissible operating pressure
Incoming water temperature
RO permeate capacity @ 5° C
Salt rejection
Water efficiency
Output pressure
Prefilter 1
Prefilter 2
Low pressure switch trigger
High pressure switch trigger
Tank sizes and types
Noise
Connection inlet
Connection pure water
Connection drain
Outer dimensions RO (HxLxW)
Outer dimensions hood (HxLxW)
Outer dimensions tank 4.5 gal DxH
Outer dimensions tank 6 gal DxH
Weight RO
Weight hood
Weight tank 4.5 gal
Weight tank 6 gal
* The Condair RO-H is energized by 24 VDC from an UL listed class 2 power source. The system
1)
needs to be protected by a ground fault circuit interruptor ≥ 5 A.
* If the pressure exceeds 50 psi, it is mandatory to install a pressure reducer upstream of the RO-H
2)
in the supply line, which is set to 50 psi max. pressure. A suitable pressure reducer is available from
Condair (2600230).
* The RO-H may only be connected to a cold water line.
3)
Unit Value
VAC / Hz 110–120 / 60
W 90
Tap water
µS/cm 150–1000
ppm 95–700
psi 8–50
psi 116
°F 41–77
gal/h 4.5
% 95–98
% ≈ 50/50
psi 43.5–87.0
Act. Carbon
Micron 5
psi 8
psi 32.0–43.5
4.5 Flow through tank
gal
6 Pressure tank
dBA <50
JG 3/8" push fit
JG 3/8" push fit
JG 1/4" push fit
inch 18.3 x 14.0 x 8.5
inch 18.5 x 15.2 x 9.8
inch 11.0 x 14.5
inch 11.0 x 16.7
lbs 18.7
lbs 8.8
lbs 10.0
lbs 9.0
*
1)
*
2)
*
3)
Product Data 13