RIDGID RT14000 Mode D'emploi page 9

ASSEMBLY
Carry Handle/Cord Wrap
Assembly
1. Locate the Carry Handle/Cord Wrap
and the two (2) #10 x 3/4" (19mm) Pan
Head Screws in loose parts bag.
2. Position the Carry Handle/Cord Wrap
on top of the Powerhead Assembly,
with the Carry Handle/Cord Wrap
Extended Flange to the rear of the
Powerhead Assembly, as shown.
3. Insert a #10 x 3/4" (19mm) Pan Head
Screw through the hole at each end
of the Carry Handle/Cord Wrap and
into the Powerhead Assembly. Tighten
securely.
#10 x 3/4" (19mm)
Pan Head Screws
(2)
Extended
Flange
Powerhead
Assembly
Hose Storage Clips Assembly
1. Locate the two (2) Hose Storage Clips
and four (4) #10 x 3/4" (19mm) Pan
Head Screws in the loose parts.
2. Place a Clip into the recess next to one
of the Latches. The Curve of the Clip
should face outward.
3. Insert a #10 x 3/4" (19mm) Pan Head
Screw into each mounting hole and
tighten securely.
4. Repeat on the other side.
#10 x 3/4" (19mm)
Pan Head Screws (2)
Hose
Clips
(1 on each
side)
Powerhead
Assembly
9